HERRITECH VENTURES LTDDairy, vending and industrial systems

H-TECH · Engineering tools

Controller Lab

Connect a controller by USB, watch every input and output live, write its settings and install firmware, straight from this page. Chrome or Edge on a computer; nothing to install.

Not connected DeviceNo controller connected Firmwarenot read yet MachineWater vending ATM RX0 BTX0 BSession00:00
  1. ConnectUSB cable, then Connect
  2. IdentifyBoard and firmware read
  3. Test & set upInputs, outputs, settings
  4. ProgramInstall H-TECH firmware
02Live boardoffline
H-TECH PLC · ATmega328P 328P RELAY D2 COIN D3 FLOW D7 UV OK D9 START A0 LEVEL D8 PUMP D10 VALVE USB / UART
activeOKfaultidle
◆Instruments
Connect a controller running H-TECH firmware and press "Watch live".
Flow scope0 pulses/s · 0.00 L/min
⚡Quick tests
⌁Wiring reference · water vending ATM
PinConnects toBehaviour
D2Coin acceptor pulseEach pulse adds the coin value to credit
D3Flow sensorCounts litres (pulses per litre in Settings)
D7UV lamp OK contactDispensing stops if UV fails
D8Pump relayOn while dispensing
D9Start buttonDispenses the button volume
D10Solenoid valve relayOpen while dispensing
A0Tank level switchBlocks dispensing when low
USBComputer / M-Pesa / GSMCommands in the terminal

Works with Arduino Uno/Nano, Controllino Mini, H-TECH boards (ATmega328P) and ESP32 boards. Branded PLCs (Siemens LOGO!, Delta, Mitsubishi) use their makers' software. Data stays between this page and your controller.